100% watertight 13P/12V socket for passenger cars, SUVs and LCVs
The new 100% watertight 13P/12V connector system by ERICH JAEGER sets the new standard in this segment. It follows our philosophy that we make connections between vehicles and trailers easier and safer.
The sophisticated, double contact system with primary and secondary lock makes together with individual wire seals the penetration of moisture into the vehicle board network impossible. Even under the most extreme conditions, the system provides 100% water-tightness. Also the draining of a sport boat into the water (submerging of the connection system) masters our connector without difficulty. The connector system satisfies all requirements of original equipment manufacturers in the automotive industry such as the protection IPX7 (waterproof up to 0.5m depth) and IPX9K (protection against water during high pressure-/ steam jet cleaning). In addition to the water-tightness our new 13P / 12V system has greatly simplified the installation options (Plug & Play).
| Model Type | Articel-No. |
| 13P/12V socket housing, according to ISO 11446-1 | 382594 |
| 13P/12V socket specific contact insert for art.-no. 382594 | 382598 |
| Seal for multicore cables | 037129 |
| Contact sleeve for wire cross-sectional area 0,5 - 1,0 mm² | 053861-4 |
| Contact sleeve for wire cross-sectional area >1,0 -2,5 mm² | 052675-4 |
| Single wire seal for wire cross-sectional area 0,5 - 1,0 mm² | 053862 |
| Single wire seal for wire cross-sectional area >1,0 -2,5 mm² | 055632 |
| Stuff plug (is mandatory for unoccupied chambers in order to ensure water tightness) | 059124 |
| Screw M5x24 | 053470-5 |
Features
- 100% water barrier from plug side to cable harness side, even when a plug is connected
- 100% watertightness from cable harness side through single wire seals
- Protection IPX7 (waterproof up to 0.5m depth) and IPX9K (steam jet resistant)
- Rear cable outlet (grommet) can be positioned every 60° on the socket housing
- New socket design with compatibility for a lot of existing mounting plates (whole diameter from 42 mm)
- Contact insert with second contact safety (OE standard)
- Easy handling for socket exchange in case of repair service (no soldering)
- Customer branding possible if required